/SAVEINF='filename' – Instructs Setup to save installation settings to the specified file.

This file can be prepared using the /SAVEINF parameter. /LOADINF='filename' – Instructs Setup to load the settings from the specified file after having checked the command line./LOG='filename' – Causes Setup to create a log file./NORESTART – Instructs installer not to reboot even if it’s necessary./CURRENTUSER – Instructs installer to install in non administrative install mode./ALLUSERS – Instructs installer to install in administrative install mode./VERYSILENT – As /SILENT, but without showing the progress window.To select the installation mode, use /ALLUSERS or /CURRENTUSER. Default selections are used for destination folder, components, etc. / SILENT – Runs the installer without any prompts (with the exception of installation mode selection and error messages).For the language, use the Code from translations page. /LANG=language – Runs the installer using the specified language.SHA1 produces a 160-bit (20-byte) hash value, usually displayed as a 40-digit hexadecimal number.You can use following parameters to automate the installation: You can upload the contents of your file to our tool or click on the 'browse' button in the editor and select your file, and then you need to click on the 'Generate' button to get the SHA-1 hash from your file. Using our tool you need just paste your TEXT or file to the textarea above and click to the button 'Generate' and you will get sha1 hash. Enter a word or some text in the sha1 online form above to know the corresponding SHA1 hash. SHA1 hash is composed of 40 hexadecimal characters. However, this is a one-way transaction, and therefore it is almost impossible to reverse the SHA1 hash to get the original string. This is just a fingerprint of this entry. This is done by producing a checksum before the file has been transmitted, and then again once it reaches its destination. SHA-1 is most often used to verify that a file has been unaltered. This message digest is usually then rendered as a hexadecimal number which is 40 digits long. SHA-1 or Secure Hash Algorithm 1 is one of several cryptographic hash functions that takes input and produces a 160-bit (20-byte) hash value.

Checksum generate tool checksum.ini